Enterasys SecureStack B3 User Manual

set dhcp
SecureStack B3 Configuration Guide 15-3
Commands
set dhcp
UsethiscommandtoenableordisabletheDHCPserverfunctionalityontheSecureStackB3.
Syntax
set dhcp {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablesDHCPserverfunctionality.
B3(rw)->set dhcp enable
For information about... Refer to page...
set dhcp 15-3
set dhcp bootp 15-4
set dhcp conflict logging 15-4
show dhcp conflict 15-4
clear dhcp conflict 15-5
set dhcp exclude 15-6
clear dhcp exclude 15-6
set dhcp ping 15-7
clear dhcp ping 15-7
show dhcp binding 15-8
clear dhcp binding 15-8
show dhcp server statistics 15-9
clear dhcp server statistics 15-9
enable|disable EnablesordisablesDHCPserverfunctionality.Bydefault,DHCPserver
isdisabled.

Enterasys SecureStack B3 Specifications

General

Brand	Enterasys
Model	SecureStack B3
Category	Switch
Language	English