Enterasys SecureStack B3

set dhcp pool
15-12 DHCP Server Configuration
set dhcp pool
UsethiscommandtocreateandassignanametoaDHCPserverpoolofaddresses.Upto16
addresspoolsmaybeconfiguredonaSecureStackB3.Notethatenteringthiscommandisnot
requiredtocreateanaddresspoolbeforeconfiguringotheraddresspoolparameters.
Syntax
set dhcp pool poolname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplecreatesanaddresspoolnamed“auto1.”
B3(rw)->set dhcp pool auto1
clear dhcp pool
UsethiscommandtodeleteaDHCPserverpoolofaddresses.
Syntax
clear dhcp pool poolname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampledeletestheaddresspoolnamed“auto1.”
B3(rw)->clear dhcp pool auto1
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.