Enterasys SecureStack B3 User Manual

show dot1x
20-10 Security Configuration
Commands
show dot1x
Usethiscommandtodisplay802.1Xstatus,diagnostics,statistics,andreauthenticationor
initializationcontrolinformationforoneormoreports.
Syntax
show dot1x [auth-diag] [auth-stats] [port [init | reauth]] [port-string]
Parameters
Defaults
Ifnoparametersarespecified,802.1Xstatuswillbedisplayed.
Ifport‐stringisnotspecified,informationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Note: To configure EAP pass-through, which allows client authentication packets to be forwarded
through the switch to an upstream device, 802.1X authentication must be globally disabled with the
set dot1x command (“set dot1x” on page 20-13).
For information about... Refer to page...
show dot1x 20-10
show dot1x auth-config 20-11
set dot1x 20-13
set dot1x auth-config 20-13
clear dot1x auth-config 20-15
show eapol 20-15
set eapol 20-17
clear eapol 20-18
auth‐diag (Optional)Displaysauthenticationdiagnosticsinformation.
auth‐stats (Optional)Displaysauthenticationstatistics.
portinit|reauth (Optional)Displaysthestatusofportinitializationandreauthentication
controlfortheport.
port‐string (Optional)Displaysinformationforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
in
theCLI”onpage 5‐1.

Enterasys SecureStack B3 Specifications

General

Brand	Enterasys
Model	SecureStack B3
Category	Switch
Language	English