Enterasys SecureStack B3 User Manual

set snmp user
SecureStack B3 Configuration Guide 6-9
Examples
ThisexampleshowshowtodisplayanSNMPuserlist:
B3(su)->show snmp user list
--- SNMP user information ---
--- List of registered users:
Guest
admin1
admin2
netops
ThisexampleshowshowtodisplayinformationfortheSNMP“guest”user:
(su)->show snmp user guest
--- SNMP user information ---
EngineId: 00:00:00:63:00:00:00:a1:00:00:00:00
Username = Guest
Auth protocol = usmNoAuthProtocol
Privacy protocol = usmNoPrivProtocol
Storage type = nonVolatile
Row status = active
Table 6‐4providesanexplanationofthecommandoutput.
set snmp user
UsethiscommandtocreateanewSNMPv3user.
Syntax
set snmp user user [remote remoteid] [authentication {md5 | sha}] [authpassword]
[privacy privpassword] [volatile | nonvolatile]
Parameters
Table 6-4 show snmp user Output Details
Output What It Displays...
EngineId SNMP local engine identifier.
Username SNMPv1 or v2 community name or SNMPv3 user name.
Auth protocol Type of authentication protocol applied to this user.
Privacy protocol Whether a privacy protocol is applied when authentication protocol is in
use.
Storage type Whether entry is stored in volatile, nonvolatile or read-only memory.
Row status Status of this entry: active, notInService, or notReady.
user SpecifiesanamefortheSNMPv3user.
remoteremoteid (Optional)RegisterstheuseronaspecificremoteSNMPengine.
authenticationmd5
|sha
(Optional)SpecifiestheauthenticationtyperequiredforthisuserasMD5
orSHA.
authpassword (Optional)Specifiesapasswordforthisuserwhenauthenticationis
required.Minimumof8characters.
privacy
privpassword (Optional)Appliesencryptionandspecifiesanencryptionpassword.
Minimumof8characters.

Enterasys SecureStack B3 Specifications

General

Brand	Enterasys
Model	SecureStack B3
Category	Switch
Language	English