Enterasys SecureStack B3 User Manual

clear lacp singleportlag
5-42 Port Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
WhensingleportLAGsareenabled,LinkAggregrationGroupscanbeformedwhenonlyone
portisreceivingprotocoltransmissionsfromapartner.Whenthissettingisdisabled,twoormore
portsarerequiredtoformaLAG.
ThissettinghasnoeffectonexistingLAGscreatedwithmultiplememberports.
Italsodoesnot
preventpreviouslyformedLAGsfromcomingupaftertheyhavegonedown,aslongasany
previousLAGmemberportscomesupconnectedtothesameswitchasbeforetheLAGwent
down.
Example
ThisexampleenablestheformationofsingleportLAGs:
B3(su)->set lacp singleportlag enable
clear lacp singleportlag
UsethiscommandtoresetthesingleportLAGfunctionbacktothedefaultstateofdisabled.
Syntax
clear lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresetthesingleportLAGfunctionbacktodisabled:
B3(su)->clear lacp singleportlag
show port lacp
Usethiscommandtodisplaylinkaggregationinformationforoneormoreunderlyingphysical
ports.
Syntax
show port lacp port port-string {[status {detail | summary}] | [counters]}

Enterasys SecureStack B3 Specifications

General

Brand	Enterasys
Model	SecureStack B3
Category	Switch
Language	English