Enterasys SecureStack B3 - Clear Lacp Static; Set Lacp Singleportlag

clear lacp static
SecureStack B3 Configuration Guide 5-41
Defaults
Ifnotspecified,akeywillbeassignedaccordingtothespecifiedaggregator.Forexampleakeyof
4wouldbeassignedtolag.0.4.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoaddportge.1.6totheLAGofaggregatorport6:
B3(su)->set lacp static lag.0.6 ge.1.6
clear lacp static
UsethiscommandtoremovespecificportsfromaLinkAggregationGroup.
Syntax
clear lacp static lagportstring port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoremovege.1.6fromtheLAGofaggregatorport6:
B3(su)->clear lacp static lag.0.6 ge.1.6
set lacp singleportlag
UsethiscommandtoenableordisabletheformationofsingleportLAGs.
Syntax
set lacp singleportlag {enable | disable}
Parameters
lagportstring SpecifiestheLAGaggregatorportfromwhichportswillberemoved.
port‐string Specifiestheport(s)toremovefromtheLAG.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage5‐1.
disable|enable EnablesordisablestheformationofsingleportLAGs.