Enterasys SecureStack B3 - Redistribute; Configuring IRDP; Purpose; Commands

redistribute
SecureStack B3 Configuration Guide 18-9
redistribute
Usethiscommandtoallowroutinginformationdiscoveredthroughnon‐RIPprotocolstobe
distributedinRIPupdatemessages.Thenoformofthiscommandclearsredistribution
parameters.
Syntax
redistribute {connected | static} [metric metric value]
no redistribute {connected | static}
Parameters
Mode
Routerconfiguration:B3(su)‐>router(Config‐router)#
Defaults
Ifmetricvalueisnotspecified,1willbeapplied.
Example
Thisexampleshowshowtoredistributeroutinginformationdiscoveredthroughstaticrouteswill
beredistributedintoRIPupdatemessages:
B3(su)->router(Config)#router rip
B3(su)->router(Config-router)#redistribute static
Configuring IRDP
Purpose
ToenableandconfiguretheICMPRouterDiscoveryProtocol(IRDP)onaninterface.This
protocolenablesahosttodeterminetheaddressofarouteritcanuseasadefaultgateway.Itis
disabledbydefault.
Commands
connected Specifiesthatnon‐RIProutinginformationdiscoveredviadirectly
connectedinterfaceswillberedistributed.
static Specifiesthatnon‐RIProutinginformationdiscoveredviastaticrouteswill
beredistributed.Staticroutesarethosecreatedusingtheiproute
commanddetailedin“iproute”onpage17‐14.
metricmetricvalue (Optional)
Specifiesametricfortheconnectedorstaticredistribution
route.Thisvalueshouldbeconsistentwiththedesignationprotocol.
For information about... Refer to page...
ip irdp enable 18-10
ip irdp maxadvertinterval 18-10
ip irdp minadvertinterval 18-11