SecureStack B3 Configuration Guide 13-1
13
Logging and Network Management
Thischapterdescribesswitch‐relatedloggingandnetworkmanagementcommandsandhowto
usethem.
Configuring System Logging
Purpose
Todisplayandconfiguresystemlogging,includingSyslogserversettings,Syslogdefaultsettings,
andtheloggingbuffer.
Commands
Note: The commands in this chapter pertain to network management of the SecureStack B3
device from the switch CLI only. For information on router-related network management tasks,
including reviewing router ARP tables and IP traffic, refer to Chapter 17.
For information about... Refer to page...
Configuring System Logging 13-1
Monitoring Network Events and Status 13-11
Managing Switch Network Addresses and Routes 13-15
Configuring Simple Network Time Protocol (SNTP) 13-25
Configuring Node Aliases 13-32
For information about... Refer to page...
show logging server 13-2
set logging server 13-3
clear logging server 13-4
show logging default 13-4
set logging default 13-5
clear logging default 13-5
show logging application 13-6
set logging application 13-7
To Next Page
Loading...
Need help?
General