Enterasys SecureStack B3

set nodealias
SecureStack B3 Configuration Guide 13-33
set nodealias
Usethiscommandtoenableordisableanodealiasagentononeormoreports,orsetthe
maximumnumberofaliasentriesperport.
Syntax
set nodealias {enable | disable | maxentries maxentries} port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Uponpacketreception,nodealiasesaredynamicallyassignedtoportsenabledwithanalias
agent,whichisthedefaultsettingonSecureStackB3devices.Nodealiasescannotbestatically
created,butcanbedeletedusingtheclearnodealiascommandasdescribedin“clearnodealias
config”onpage 13‐34.
Example
Thisexampleshowshowtodisablethenodealiasagentonge.1.3:
B3(su)->set nodealias disable ge.1.3
Table 13-7 show nodealias config Output Details
Output What It Displays...
Port Number Port designation.
Max Entries Maximum number of alias entries configured for this port.
Used Entries Number of alias entries (out of the maximum amount configured) already used by
this port.
Status Whether or not a node alias agent is enabled (default) or disabled on this port.
enable|disable Enablesordisablesanodealiasagent.
maxentriesmaxentries Setthemaximumnumberofaliasentriesperports.Validrangeis0to
4096.Thedefaultvalueis32.
port‐string Specifiestheport(s)onwhichtoenable/disablenodealiasagentorset
amaximumnumberofentries.