Enterasys SecureStack B3

clear ipv6 address
19-4 IPv6 Management
Syntax
show ipv6 address
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
ThiscommanddisplaystheIPv6addressesconfiguredautomaticallyandwiththesetipv6
addressandsetipv6gatewaycommands.
Example
ThisexampledisplaysthreeIPv6managementaddressesconfiguredfortheswitch.
B3(su)->show ipv6 address
Name IPv6 Address
------------ ----------------------------------------
host FE80::201:F4FF:FE5C:2880/64
host 2001:DB8:1234:5555:201:F4FF:FE5C:2880/64
gateway FE80::201:F4FF:FE5D:1234
clear ipv6 address
UsethiscommandtoclearIPv6globaladdresses.
Syntax
clear ipv6 [address {all|ipv6-addr/prefix-length}]
Parameters
Defaults
Ifaddressisnotentered,allmanuallyconfiguredglobalIPv6addressesarecleared.
Mode
Switchmode,read‐write.
ipv6‐addr TheIPv6addresstobecleared.Thisparametermustbeintheform
documentedinRFC4291,withtheaddressspecifiedinhexadecimalusing
16‐bitvaluesbetweencolons.
prefix‐length ThelengthoftheIPv6prefix forthisaddress.Thevalueofprefix‐lengthisa

decimalnumberindicatingthenumberofhigh‐ordercontiguousbitsofthe
addressthatcomprisethenetworkportionoftheaddress.
all DeletesallIPv6globaladdresses.