Enterasys SecureStack B3

Event Group Commands
SecureStack B3 Configuration Guide 14-11
Syntax
clear rmon alarm index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearRMONalarmentry1:
B3(rw)->clear rmon alarm 1
Event Group Commands
Purpose
TodisplayandclearRMONevents,andtoconfigureRMONeventproperties.
Commands
show rmon event
UsethiscommandtodisplayRMONevententryproperties.
Syntax
show rmon event [index]
Parameters
Defaults
Ifindexisnotspecified,informationabou tallRMONentrieswillbedisplayed.
index Specifiestheindexnumberofentrytobecleared.
For information about... Refer to page...
show rmon event 14-11
set rmon event properties 14-12
set rmon event status 14-13
clear rmon event 14-14
index (Optional)DisplaysRMONpropertiesandlogentriesforaspecificentry
indexID.