Enterasys SecureStack B3

SecureStack B3 Configuration Guide 9-1
9
Differentiated Services Configuration
ThischapterdescribestheDifferentiatedServices(Diffserv)setofcommandsandhowtouse
them.
SecureStackB3devicessupportDiffservpolicy‐basedprovisioningofnetworkresourcesby
allowingITadministratorsto:
•Create,changeorremoveDiffservpoliciesbasedonbusiness‐specificuseofnetworkservices.
• Prioritizeandpolicetrafficaccordingtoassigned
policiesandconditions.
• AssignorunassignportstoDiffservpoliciessothatonlyportsactivatedforapolicywillbe
allowedtotransmitframesaccordingly.
Globally Enabling or Disabling Diffserv
Purpose
Toglobal lyenableordisableDiffservonthedevice.
Command
ThecommandusedtogloballyenableordisableDiffservonthedeviceislistedbelowand
describedintheassociatedsectionasshown.
Note: Diffserv will not be available if a Policy License is activated on the SecureStack B3. When a
Policy License is activated, it enables Policy that takes the place of Diffserv. Refer to “Activating
Licensed Features” on page 3-26 for more information on Licensing.
For information about ... Refer to page ...
Globally Enabling or Disabling Diffserv 9-1
Creating Diffserv Classes and Matching Conditions 9-2
Configuring Diffserv Policies and Assigning Classes 9-9
Assigning Policies to Service Ports 9-15
DiffServ Configuration Examples 9-17
For information about... Refer to page...
set diffserv adminmode
9‐1