Enterasys SecureStack B3 - Show Lldp Port Tx-Tlv

show lldp port tx-tlv
SecureStack B3 Configuration Guide 4-17
Parameters
Defaults
Ifport‐stringisnotspecified,LLDPporttrapinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLLDPporttrapinformationforallports.
B3(ro)->show lldp port trap
Trap-Enabled Ports :
MED Trap-Enabled Ports:
show lldp port tx-tlv
UsethiscommandtodisplayinformationaboutwhichoptionalTLVshavebeenconfiguredtobe
transmittedonports.PortsareconfiguredtosendoptionalTLVswiththesetlldpporttx‐tlv
command.
Syntax
showlldpporttx‐tlv[port‐string]
Parameters
Defaults
Ifport‐stringisnotspecified,TLVconfiguration informationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
port‐string (Optional)Displaystheportorrangeofportsthathavebeenenabled
tosendLLDPand/orLLDP‐MEDnotifications.
port‐string (Optional)DisplaysinformationaboutTLVconfigurationforoneora
rangeofports.