Enterasys SecureStack B3

set spantree portadmin
7-32 Spanning Tree Configuration
Commands
set spantree portadmin
UsethiscommandtodisableorenabletheSpanningTreealgorithmononeormoreports.
Syntax
set spantree portadmin port-string {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisableSpanningTreeonge.1.5:
B3(rw)->set spantree portadmin ge.1.5 disable
clear spantree portadmin
UsethiscommandtoresetthedefaultSpanningTreeadminstatustoenableononeormoreports.
For information about... Refer to page...
set spantree portadmin 7-32
clear spantree portadmin 7-32
show spantree portadmin 7-33
show spantree portpri 7-33
set spantree portpri 7-34
clear spantree portpri 7-35
show spantree adminpathcost 7-35
set spantree adminpathcost 7-36
clear spantree adminpathcost 7-36
show spantree adminedge 7-37
set spantree adminedge 7-37
clear spantree adminedge 7-38
port‐string Specifiestheport(s)forwhichtoenableordisableSpanning Tree.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐1.
disable|enable DisablesorenablesSpanningTree.