Enterasys SecureStack B3

show policy maptable response
20-42 Security Configuration
InordertoauthenticatemultipleRFC3580users,policymaptableresponsemustbesettotunnel
asdescribedinthissection.
Commands
show policy maptable response
Displaysthecurrentpolicymaptableresponsesetting.Whenmaptableresponseissettopolicy
(thedefaultsetting)themaximumnumberofmultiauthusersallowedperportis2.Whenthe
maptableresponseissettotunnelthemaximumnumberofmultiauthusersallowedperportis6
3.WhenVLANauthorization
isenabled(asdescribedinthissection)andthepolicymaptable
responseistunnel,youcanusethe“setmultiauthport”onpage 20‐35command tosetthe
numberofRFC3580users(numusers)allowedperGigabitport.Uptothreeuserscanbe
configuredperGigabitport..
Syntax
show policy maptable response
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythecurrentpolicymaptableresponsesetting:
B3(rw)->show policy maptable response
policy
set policy maptable response
Setsthemaptableresponsefromthedefaultofpolicytotunneltoallowupto3VLANauthorized
userstobeconfiguredperGigabitport.
For information about... Refer to page...
show policy maptable response 20-42
set policy maptable response 20-42
set vlanauthorization 20-43
set vlanauthorization egress 20-44
clear vlanauthorization 20-44
show vlanauthorization 20-45