Enterasys SecureStack B3

SecureStack B3 Configuration Guide 3-1
3
Basic Configuration
Atstartup,theSecureStackB3switchisconfiguredwithmanydefaultsandstandardfeatures.
Thischapterdescribeshowtocustomizebasicsystemsettingstoadapttoyourworkenvironment.
Setting User Accounts and Passwords
Purpose
Tochangethe switch’sdefaultuserloginandpasswordsettings,andtoaddnewuseraccounts
andpasswords.
Commands
Thecommandsusedtoconfigureuseraccountsandpasswordsarelistedbelow.
For information about... Refer to page...
Setting User Accounts and Passwords 3-1
Setting Basic Switch Properties 3-8
Activating Licensed Features 3-26
Configuring Power over Ethernet (PoE) 3-31
Downloading a New Firmware Image 3-34
Reviewing and Selecting a Boot Firmware Image 3-36
Starting and Configuring Telnet 3-38
Managing Switch Configuration and Files 3-40
Clearing and Closing the CLI 3-49
Resetting the Switch 3-50
Using and Configuring WebView 3-52
For information about... Refer to page...
show system login 3-2
set system login 3-3
clear system login 3-3
set password 3-4