show ciscodp port info
4-8 Discovery Protocol Configuration
show ciscodp port info
UsethiscommandtodisplaysummaryinformationabouttheCiscodiscoveryprotocolononeor
moreports.
Syntax
show ciscodp port info [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,CiscoDPinformationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayCiscoDPinformationforGigabitEthernetport1inslot1.
B3(su)->show ciscodp port info ge.1.1
port state vvid trusted cos
----------------------------------------------
ge.1.1 enable none yes 0
Table 4‐3providesanexplanationofthecommandoutput.
Timer The number of seconds between Cisco discovery protocol PDU transmissions. The
default of 60 seconds can be reset with the set ciscodp timer command.
Holdtime Number of seconds neighboring devices will hold PDU transmissions from the
sending device. Default value of 180 can be changed with the set ciscodp holdtime
command.
Device ID The MAC address of the switch.
Last Change The time that the last Cisco DP neighbor was discovered.
Table 4-2 show ciscodp Output Details (Continued)
Output What It Displays...
port‐string (Optional)DisplaysCiscoDPinformationforaspecificport.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage5‐1.
Table 4-3 show ciscodp port info Output Details
Output What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 5-1.
State Whether Cisco DP is enabled, disabled or auto-enabled on the port. Default state of
enabled can be changed using the set ciscodp port command.
vvid Whether a voice VLAN ID has been set on this port. Default of none can be changed
using the set ciscodp port command.
To Next Page
Loading...
Need help?
General