Enterasys SecureStack B3

History Group Commands
SecureStack B3 Configuration Guide 14-5
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodeleteRMONstatisticsentry2:
B3(rw)->clear rmon stats 2
History Group Commands
Purpose
Todisplay,configure,andclearRMONhistorypropertiesandstatistics.
Commands
show rmon history
UsethiscommandtodisplayRMONhistorypropertiesandstatistics.TheRMONhistorygroup
recordsperiodicstatisticalsamplesfromanetwork.
Syntax
show rmon history [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,informationaboutallRMONhistoryentrieswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONhistoryentriesforGigabitEthernetport1inswitch1.
Acontrolentrydisplaysfirst,followedbyactualentriescorrespondingtothecontrolentry.Inthis
case,thedefaultsettingsforentryowner,samplinginterval,andmaximumnumberofentries.
(buckets)havenotbeen
changedfromtheirdefaultvalues.Foradescriptionofthetypesof
statisticsshown,refertoTable 14‐2.
:
For information about... Refer to page...
show rmon history 14-5
set rmon history 14-6
clear rmon history 14-7
port‐string (Optional)DisplaysRMONhistoryentriesforspecificport(s).