Enterasys SecureStack B3

set diffserv policy class
SecureStack B3 Configuration Guide 9-11
Mode
Switchcommand,read‐write.
Usage
Inordertodeleteapolicyyoumustfirstremovetheserviceport(s)assignedtothepolicyusing
thesetdiffservserviceremovecommandasdescribedin“setdiffservservice”onpage9‐16.
Example
ThisexampleshowshowtodeletetheDiffserv“admin”policy:
B3(rw)->set diffserv policy delete admin
set diffserv policy class
UsethiscommandtoaddorremoveaDiffservclasstoaspecifiedpolicy.Onceadded,policies
willbeactiveforthespecifiedclass.
Syntax
set diffserv policy class {add | remove} policyname classname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Classmustbeaddedtoapolicyusingthiscommandbeforepolicyparameters,suchas
bandwidth,marking,andpolicing,canbeconfigured.
Example
Thisexampleshowshowtoaddthe“system”classtothe“admin”policy:
B3(rw)->set diffserv policy class add admin system
set diffserv policy mark
UsethiscommandtomarkallpacketsfortheassociatedDiffservtrafficstreamwithaspecificIP
DSCPorIPprecedencevalue.
Syntax
set diffserv policy mark {ipdscp | ipprecedence policyname classname value}
add|remove Addsorremovesthespecifiedclass.
policyname Specifiesthepolicynametobeassociatedwiththeclass.
classname Specifiesaclassnametoaddorremove.