To Next Page

To Previous Page

set ipv6 gateway

SecureStack B3 Configuration Guide 19-5

Usage

Thiscommandclearsaddressesmanuallyconfiguredwiththesetipv6addresscommand.Usethe

clearipv6gatewaycommandtocleartheIPv6gatewayaddress.

Example

Thisexampleillustratesthatthiscommand clearsonlythose IPv6addressesconfiguredwiththe

setipv6addresscommand.Thelink‐localaddressforthehostinterfaceandthegatewayaddress

arenotremovedwiththiscommand.

B3(su)->show ipv6 address

Name IPv6 Address

------------ ----------------------------------------

host FE80::201:F4FF:FE5C:2880/64

host 2001:DB8:1234:5555:201:F4FF:FE5C:2880/64

host 2001:DB8:1234:5555::9876:2/64

gateway FE80::201:F4FF:FE5D:1234

B3(su)->clear ipv6 address all

B3(su)->show ipv6 address

Name IPv6 Address

------------ ----------------------------------------

host FE80::201:F4FF:FE5C:2880/64

gateway FE80::201:F4FF:FE5D:1234

set ipv6 gateway

UsethiscommandtoconfiguretheIPv6gateway(defaultrouter)address.

Syntax

set ipv6 gateway ipv6-addr

Parameters

Defaults

None.

Mode

Switchmode,read‐write.

Usage

ThiscommandconfigurestheIPv6gatewayaddress.OnlyoneIPv6gatewayaddresscanbe

configuredfortheswitch,soexecutingthiscommandwhenagatewayaddresshasalreadybeen

configuredwilloverwritethepreviouslyconfiguredaddress.

Usetheshowipv6addresscommandtodisplayaconfiguredIPv6gatewayaddress.

ipv6‐addr The

IPv6addresstobeconfigured.Theaddresscanbeaglobalunicastor

link‐localIPv6address,intheformdocumentedinRFC4291,withthe

addressspecifiedinhexadecimalusing16‐bitvaluesbetweencolons.

Enterasys SecureStack B3 User Manual

Questions and Answers: