Enterasys SecureStack B3

set macauthentication portquietperiod
SecureStack B3 Configuration Guide 20-25
set macauthentication portquietperiod
Thissetsthenumberofsecondsfollowingafailedauthenticationbeforeanotherattemptmaybe
madeontheport.
Syntax
set macauthentication portquietperiod time port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsport1towait5secondsafterafailedauthenticationattemptbeforeanew
attemptcanbemade:
B3(su)->set macauthentication portquietperiod 5 ge.1.1
clear macauthentication portquietperiod
Thissetsthequietperiodbacktothedefaultvalue.
Syntax
clear macauthentication portquietperiod [port-string]
Parameters
Defaults
Ifaport‐stringisnotspecifiedthenallportswillbesettothedefaultportquietperiod.
Mode
Switchcommand,read‐write.
Example
Thisexampleresetsthedefaultquitperiodonport1:
B3(su)->clear macauthentication portquietperiod ge.1.1
time Periodinsecondstowaitafterafailedauthentication
port‐string Specifiestheportsforwhichthequitperiodistobeapplied.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 5 ‐1. 
port‐string (Optional)Specifiestheportsforwhichthequietperiodistobereset.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐1.