Enterasys SecureStack B3

set linkflap portstate
SecureStack B3 Configuration Guide 5-23
set linkflap portstate
Usethiscommandtoenableordisablelinkflapmonitoringononeormoreports.
Syntax
set linkflap portstate {disable | enable} [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,allportsareenabledordisabled.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoenablethelinktrapmonitoringonallports.
B3(rw)->set linkflap portstate enable
set linkflap interval
Usethiscommandtosetthetimeinterval(inseconds)foraccumulatinglinkdowntransitions.
Syntax
set linkflap interval port-string interval-value
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthelinkflapintervalonportge.1.4to1000seconds.
B3(rw)->set linkflap interval ge.1.4 1000
disable|enable Disablesorenablesthelinkflapdetectionfunction.
port‐string (Optional)Specifiestheportorportsonwhichtodisableorenable
monitoring.
port‐string Specifiestheport(s)onwhichtosetthelinkflapinterval.
interval‐value Specifiesanintervalinseconds.Avalueof0willsettheintervalto
forever.