To Next Page

To Previous Page

ip rip send version

18-4 IPv4 Routing Protocol Configuration

B3(su)->router(Config-router)#distance 100

ip rip send version

UsethiscommandtosettheRIPversion(s)forupdatepacketstransmittedonaninterface.Theno

formofthiscommandrestorestheversionofupdatepacketsthatwastransmittedbytheRIP

router.

Syntax

ip rip send version {1 | 2 | r1compatible}

no ip rip send version

Parameters

Defaults

None.

Mode

Interfaceconfiguration:B3(su)‐>router(Config‐if(Vlan1))#

Example

ThisexampleshowshowtosettheRIPsendversionto2forpacketstransmittedontheVLAN1

interface:

B3(su)->router(Config)#interface vlan 1

B3(su)->router(Config-if(Vlan 1))#ip rip send version 2

ip rip receive version

UsethiscommandtosettheRIPversion(s)forupdatepacketsacceptedontheinterface.Theno

formofthiscommandrestoresthedefaultversionoftheRIProuterupdatepacketsthatare

acceptedontheinterface.

Syntax

ip rip receive version {1 | 2 | 1 2 | none}

no ip rip receive version

Parameters

1 SpecifiesRIPversion1.Thisisthedefaultsetting.

2 SpecifiesRIPversion2.

r1compatible Specifiesthatpacketsbesentasversion2packets,buttransmitstheseas

broadcastpacketsratherthanmulticastpacketssothatsystemswhichonly

understandRIPversion1canreceivethem.

1 SpecifiesRIPversion1.Thisisthedefaultsetting.

2 SpecifiesRIPversion2.

12 SpecifiesRIPversions1and2.

none SpecifiesthatnoRIProuteswillbeprocessedonthisinterface.

Enterasys SecureStack B3 User Manual

Questions and Answers: