Enterasys SecureStack B3

show pwa
20-58 Security Configuration
show pwa
Usethiscommandtodisplayportwebauthenticationinformationforoneormoreports.
Syntax
show pwa [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,PWAinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayPWAinformationforge.2.1:
B3(su)->show pwa ge.2.1
PWA Status - enabled
PWA IP Address - 192.168.62.99
PWA Protocol - PAP
PWA Enhanced Mode - N/A
PWA Logo - enabled
PWA Guest Networking Status - disabled
PWA Guest Name - guest
PWA Redirect Time - N/A
Port Mode AuthStatus QuietPeriod MaxReq
-------- ---------------- -------------- ----------- ---------
ge.2.1 disabled disconnected 60 16
Table 20‐8providesanexplanationofthecommandoutput.
set pwa gueststatus 20-64
set pwa initialize 20-65
set pwa quietperiod 20-66
set pwa maxrequest 20-66
set pwa portcontrol 20-67
show pwa session 20-67
set pwa enhancedmode 20-68
For information about... Refer to page...
port‐string (Optional)DisplaysPWAinformationforspecificport(s).