Enterasys SecureStack B3

ip irdp broadcast
SecureStack B3 Configuration Guide 18-13
ip irdp broadcast
UsethiscommandtoconfigureIRDPtousethelimitedbroadcastaddressof255.255.255.255.The
defaultismulticastwithaddress224.0.0.1.ThenoformofthiscommandresetsIRDPtouse
multicastonIPaddress224.0.0.1.
Syntax
ip irdp broadcast
no ip irdp broadcast
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:B3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenablebroadcastforIRDPontheVLAN1interface:
B3(su)->router(Config)#interface vlan 1
B3(su)->router(Config-if(Vlan 1))#ip irdp broadcast
show ip irdp
UsethiscommandtodisplayIRDPinformation.
Syntax
show ip irdp [vlan vlan-id]
Parameters
Defaults
Ifvlanvlan‐idisnotspecified,IRDPinformationforallinterfaceswillbedisplayed.
Mode
Interfaceconfiguration:B3(su)‐>router(Config‐if(Vlan1))#
vlanvlan‐id (Optional)DisplaysIRDPinformationforaspecificVLAN .ThisVLAN
mustbeconfiguredforIProutingasdescribedin“Pre‐Routing
ConfigurationTasks”onpage16‐1.