Enterasys SecureStack B3

show rmon filter
SecureStack B3 Configuration Guide 14-17
show rmon filter
UsethiscommandtodisplayoneormoreRMONfilterentries.
Syntax
show rmon filter [index index | channel channel]
Parameters
Defaults
Ifnooptionsarespecified,informationforallfilterentrieswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayallRMONfilterentriesandchannelinformation:
B3(rw)->show rmon filter
Index= 55508 Channel Index= 628 EntryStatus= valid
----------------------------------------------------------
Data Offset 0 PktStatus 0
PktStatusMask 0 PktStatusNotMask 0
Owner ETS,NAC-D
-----------------------------
Data
ff ff ff ff ff ff
-----------------------------
DataMask
ff ff ff ff ff ff
-----------------------------
DataNotMask
00 00 00 00 00 00
set rmon filter
UsethiscommandtoconfigureanRMONfilterentry.
Syntax
set rmon filter index channel-index [offset offset] [status status] [smask smask]
[snotmask snotmask] [data data] [dmask dmask] [dnotmask dnotmask] [owner owner]
Parameters
indexindex|
channelchannel
(Optional)Displaysinformationaboutaspecificfilterentry,oraboutall
filterswhichbelongtoaspecificchannel.
index Specifiesanindexnumberforthisentry.Anentrywillautomaticallybe
createdifanunusedindexnumberischosen.Maximumnumberof
entriesis10.Maximum valueis65535.
channel‐index Specifiesthechanneltowhichthisfilterwillbeapplied.