Enterasys SecureStack B3

Configuring SNMP Target Parameters
6-22 SNMP Configuration
Configuring SNMP Target Parameters
Purpose
ToreviewandconfigureSNMPtargetparameters.Thiscontrolswhereandunderwhat
circumstancesSNMPnotificationswillbesent.Atargetparameterentrycanbeboundtoatarget
IPaddressallowedtoreceiveSNMPnotificationmessageswiththesetsnmptargetaddr
command(“setsnmptargetaddr”onpage 6‐26).
Commands
show snmp targetparams
UsethiscommandtodisplaySNMPparametersusedtogenerateamessagetoatarget.
Syntax
show snmp targetparams [targetParams] [volatile | nonvolatile | read-only]
Parameters
Defaults
IftargetParamsisnotspecified,entriesassociatedwithalltargetparameterswillbedisplayed.
Ifnotspecified,entriesofallstoragetypeswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySNMPtargetparametersinformation:
B3(su)->show snmp targetparams
--- SNMP TargetParams information ---
Target Parameter Name = v1ExampleParams
Security Name = public
Message Proc. Model = SNMPv1
Security Level = noAuthNoPriv
Storage type = nonVolatile
Row status = active
For information about... Refer to page...
show snmp targetparams 6-22
set snmp targetparams 6-23
clear snmp targetparams 6-24
targetParams (Optional)Displaysentriesforaspecifictargetparameter.
volatile|nonvolatile|
read‐only
(Optional)Displaystargetparameterentriesforaspecificstorage
type.