Enterasys SecureStack B3 - Page 522

set dot1x auth-config
20-14 Security Configuration
[reauthperiod value] [servertimeout timeout] [supptimeout timeout] [txperiod
value]} [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,authenticationparameterswillbesetonallports.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtoenablereauthenticationcontrolonportsge.1.1‐3:
B3(su)->set dot1x auth-config reauthenabled true ge.1.1-3
Thisexampleshowshowtosetthe802.1Xquietperiodto120secondsonportsge.1.1‐3:
B3(su)->set dot1x auth-config quietperiod 120 ge.1.1-3
authcontrolled‐
portcontrol
auto|forced‐auth|
forced‐unauth
Specifiesthe802.1Xportcontrolmode.
• auto–Setportcontrolmodetoautocontrolledportcontrol.This
isthedefaultvalue.
• forced‐auth–SetportcontrolmodetoForcedAuthorized
controlledportcontrol.
• forced‐unauth–Setportcontrolmodeto
ForcedUnauthorized
controlledportcontrol.
maxreqvalue Specifies themaximumnumberofauthenti cationrequestsallowed
bythebackendauthenticationstatemachine.Validvaluesare1–10.
Defaultvalueis2.
quietperiodvalue Specifiesthetime(inseconds)followingafailedauthentication
beforeanotherattemptcanbemadebytheauthenticator PAEstate
machine.Validvaluesare0–65535.Defaultvalueis60seconds.
reauthenabledfalse|
true
Enables(true)ordisables(false)reauthenticationcontrolofthe
reauthenticationtimerstatemachine.Defaultvalueisfalse.
reauthperiodvalue Specifiesthetimelapse(inseconds)betweenattemptsbythe
reauthenticationtimerstatemachineto
reauthenticateaport.Valid
valuesare0–65535.Defaultvalueis3600seconds.
servertimeouttimeout Specifiesatimeoutperiod(inseconds)fortheauthenticationserver,
usedbythebackendauthenticationstatemachine.Validvaluesare1
–300.Defaultvalueis30seconds.
supptimeouttimeout Specifiesatimeoutperiod(in
seconds)fortheauthentication
supplicantusedbythebackendauthenticationstatemachine.Valid
valuesare1–300.Defaultvalueis30seconds.
txperiodvalue Specifies theperiod(inseconds)whichpassesbetweenauthenticator
PAEstat emachineEAPtransmissions.Validvaluesare0–65535.
Defaultvalueis30seconds.
port
‐string (Optional)Limitstheconfigurationofdesiredsettingstospecified
port(s).Foradetaileddescriptionofpossibleport‐stringvalues,refer
to“PortSt ringSyntaxUsedintheCLI”onpage 5‐1.