Enterasys SecureStack B3 - Page 507

traceroute ipv6
SecureStack B3 Configuration Guide 19-9
Syntax
traceroute ipv6 ipv6-addr [port]
Parameters
Defaults
None.
Mode
Switchmode,read‐write.
Usage
Thiscommandisalsoavailableinroutermode.
Example
Thisexampleshowshowtousetraceroutetodisplayaroundtrippathtohost
2001:0db8:1234:5555::1.
B3(su)->router#traceroute ipv6 2001:0db8:1234:5555::1
Traceroute to 2001:0db8:1234:5555::1, 30 hops max, 40 byte packets
1 2001:0db8:1234:5555::1 1.000000e+00 ms 1.000000e+00 ms 1.000000e+00 ms
ipv6‐addr SpecifiesahosttowhichtherouteofanIPv6packetwillbetraced.Enterthe
addressintheformdocumentedinRFC4291,withtheaddressspecifiedin
hexadecimalusing16‐bitvaluesbetweencolons.
port (Optional)SpecifiestheUDPportusedasthedestinationofpacketssentas
partofthetraceroute.Thisportshouldbeanunusedportonthedestination
system.Thevalueofportcanrangefrom0to65535.Defaultvalueis33434.