Quick Recording a Backing Sequence Song |289
Recording
Turn on the metronome
▪ Press the METRONOME ( ) button to turn the metronome on or off while
recording.
Select the tracks to record
▪ Select or deselect the Backing Sequence grouped tracks (Kbd and Ch/Acc).
This status is reflected by the big status indicator above the track sliders.
Track status Meaning
Rec The Backing Sequence grouped track is in record. All previously
recorded data will be deleted. After pressing the PLAY/STOP
( ) button to start recording, the track will receive notes from
the keyboard or the USB DEVICE connector.
Play The Backing Sequence track is set to play. If there are recorded
data, they will be heard while recording the other Backing
Sequence grouped track.
Mute The Backing Sequence grouped track is muted. If this track has
already been recorded, it will not be heard during recording of the
other Backing Sequence track.
The Ch/Acc Backing Sequence track groups all the Style tracks, together
with recognized chords and Style controls and Style Elements selection.
The Kbd Backing Sequence track contains the four Keyboard Sounds.
Record
1 Select the Style Element you want to use before starting to play. Select any
of the Variations before starting to record. Select one of the Intros to start
with an introduction.
2 Press the START/STOP button to start recording.
A 1-measure precount will play before the recording actually begins. When
it begins, record freely.
3 Play as if you were performing live with the Styles.
During recording, select any Style Element (Intro, Variation, Fill, Break,
Ending…) you like. While recording in Backing Sequence Record mode, you
cannot use the Synchro, Tap Tempo, Balance controls.
To Next Page
Loading...
Need help?
General
