Dynamics (Dynamic) |405
e Gain Adjust [dB] –Inf, –38…+24 Sets the output gain
Src Of f…Tempo Selects the modulation source for
the output gain
Amt –63…+63 Sets the modulation amount of the
output gain
f Side PEQ Insert Off, On Toggles between on/off of the trigger
signal’s EQ
Trigger Monitor Off, On Switches between effect output
monitor and trigger signal monitor
g Side PEQ Cutoff [Hz] 2 0…12. 0 0 k Sets the EQ center frequency for the
trigger signal
Q 0.5…10.0 Sets the EQ bandwidth for the trig-
ger signal
Gain [dB] –18.0…+18.0 Sets the EQ gain for the trigger sig-
nal
h Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Of f…Tempo Dynamic Modulation sources
Amt –100…+100 Amount of modulation source
a: Envelope Select
When L/R Mix is selected for this parameter, the left and right channels are
linked to control the Limiter using the mixed signal. If L Only (or R Only) is
selected, the left and right channels are linked, and the Limiter is controlled
via only the left (or right) channel.
With L/R individually, the left and right channels control the Limiter individu-
ally.
b: Ratio
c: Threshold [dB]
e: Gain Adjust [dB]
This parameter sets the signal compression “Ratio”. Compression is applied
only when the signal level exceeds the “Threshold” value.
To Next Page
Loading...
