438| Effects for the MIDI Sounds
f Low Cutoff [Hz] 2 0 …1. 0 0 k Sets the center frequency for Low EQ
(shelving type)
Gain [dB] –18…+18 Sets the gain of Low EQ
g Mid1Cutoff [Hz] 300…10.00k Sets the center frequency for Mid/High
EQ 1 (peaking type)
Q 0.5…10.0 Sets the band width of Mid/High EQ 1
Gain [dB] –18…+18 Sets the gain of Mid/High EQ 1
h Mid2 Cutoff [Hz] 500…20.00k Sets the center frequency for Mid/High
EQ 2 (peaking type)
Q 0.5…10.0 Sets the band width of Mid/High EQ 2
Gain [dB] –18…+18 Sets the gain of Mid/High EQ 2
i Direct Mix 0…50 Sets the amount of the dry sound mixed
to the distortion
Speaker Simulation Off, On Switches the speaker simulation on/off
j Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Of f…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Wah
The Wah parameter switches the wah effect on/off.
a: Sw
This parameter sets how the wah effect is switched on and off via the modu-
lation source.
When “Sw” = Moment, the wah effect is usually turned off. It is turned on
only when you press the pedal or operate the joystick.
When a value for the modulation source is less than 64, “off” speed is
selected, and when the value is 64 or higher, “on” is selected.
When “Sw” = Toggle, the wah effect is switched between on and off each
time you press the pedal or operate the joystick.
The switch will be turned on/off each time the value of the modulation
source exceeds 64.
To Next Page
Loading...
