Overdrive, Amp models, and Mic models (OD Amp Mic) |439
b: Wah Sweep Range
b: Wah Sweep Src
This parameter sets the sweep range of the wah center frequency. A nega-
tive value will reverse the direction of sweep. The wah center frequency can
be controlled by the modulation source specified in the “Wah Sweep Src”
parameter.
d: Pre Low-cut
Cutting the signal in the low range before it is input to the Distortion will cre-
ate a sharp distortion.
d: Drive
e: Output Level
The degree of distortion is determined by the level of input signal and the
setting of “Drive”. Raising the “Drive” setting will cause the entire volume
level to increase. Use the “Output Level” parameter to adjust the volume
level. The “Output Level” parameter uses the signal level input to the 3-Band
EQ. If clipping occurs at the 3-Band EQ, adjust the “Output Level” parameter.
To Next Page
Loading...
