Chapter 5 Introduction to Advanced Troubleshooting 5-7
■ The workstation must be booted to the multiuser level (run level 3).
■ To run SunVTS software with a GUI, that GUI must be installed. Otherwise, run
SunVTS software with the TTY-mode interface.
5.6.3 SunVTS Documentation
Because of its complexity and depth of application, SunVTS software is not
thoroughly discussed in this book. In-depth SunVTS information can be found in:
■ SunVTS 5.1 User’s Guide describes how to install, configure, and run the SunVTS
diagnostic software.
■ SunVTS Quick Reference Card provides an overview of how to use the SunVTS
CDE interface.
■ SunVTS 5.1 Test Reference Manual provides details about each individual SunVTS
test.
■ SunVTS 5.1 Patch Set 5 Documentation Supplement provides information specific for
Solaris 8 2/04 and Solaris 9 9/04 operating systems.
5.7 Sun Install Check
5.7.1 Sun Install Check Overview
The Sun Install Check tool verifies and provides information about your Sun Blade
1500 workstation hardware and software configuration. Before you can run the Sun
Install Check tool, you need to download it from the following web site:
http://wwws.sun.com/software/installcheck/index.html
The following procedure describes how to download the Sun Install Check tool.
When installed, the Sun Install Check tool occupies 15 MB of drive space.
5.7.2 Downloading Sun Install Check
1. As superuser of the Sun Blade 1500 workstation, open a web browser and go to
the Install Check web site:
http://wwws.sun.com/software/installcheck/index.html
To Next Page
Loading...
