Sun Microsystems Blade 1500 - Removing the Speaker; TABLE 13-4 Speaker Specifications

13-40 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
TABLE 13-4 lists the speaker specifications.
13.6.2 Removing the Speaker
1. Power off the system, open the chassis, and remove the bezel.
Refer to:
■ “Powering Off the Workstation” on page 10-4
■ “Removing the Access Panel” on page 10-12
■ “Removing the Bezel” on page 10-14
2. Locate the speaker bracket.
The speaker is housed in a green plastic bracket that attaches to the workstation
chassis. See
FIGURE 13-42.
3. Open the bezel cable clip at the center of the chassis and remove the speaker cable
from the clip.
See FIGURE 13-43.
TABLE 13-4 Speaker Specifications
Specification Value
Impedance 8 Ohms
Wattage 3.5 W