Sun Microsystems Blade 1500 - Openboot Diagnostics Tests

8-8 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
The following is a successful pmu@6 test.
If a test detects an error, an error message is displayed. The following is an example
of a flashprom@2,0 test error.
In this situation, the binary code that identifies POST was corrupted in the
motherboard flash PROM. The motherboard was replaced.
8.2.6 OpenBoot Diagnostics Tests
The OpenBoot PROM for the Sun Blade 1500 workstation can perform the following
diagnostic tests:
■ “SUNW,XVR-600@3 Test” on page 8-11
■ “card-reader@0,40 Test” on page 8-11
■ “flashprom@2,0 Test” on page 8-12
■ “i2c@0,320 Test” on page 8-13
■ “ide@d Test” on page 8-14
■ “network@2 Test” on page 8-14
■ “parallel@0,378 Test” on page 8-17
■ “pmu@6 Test” on page 8-17
■ “rtc@0,70 Test” on page 8-18
■ “serial@0,2e8 Test” on page 8-18
■ “serial@0,3f8 Test” on page 8-18
■ “sound@8 Test” on page 8-19
obdiag> test 8
Hit the spacebar to interrupt testing
Testing /pci@1e,600000/pmu@6
Subtest pmu-reg-test
Selftest at /pci@1e,600000/pmu@6 ...................................... passed
Pass:1 (of 1) Errors:0 (of 0) Tests Failed:0 Elapsed Time: 0:0:0:0
ERROR : There is no POST in this FLASHPROM or POST header is unrecognized
DEVICE : /pci@1e,600000/isa@7/flashprom@2,0
SUBTEST : selftest:crc-subtest
MACHINE : Sun Blade 1500 (Silver)
SERIAL# : 51221819
DATE : 11/03/2004 00:21:40 GMT
CONTR0LS: diag-level=max test-args=loopback,debug
Error: /pci@1e,600000/isa@7/flashprom@2,0 selftest failed, return code = 1
Selftest at /pci@1e,600000/isa@7/flashprom@2,0 (errors=1) ............. failed
Pass:1 (of 1) Errors:1 (of 1) Tests Failed:1 Elapsed Time: 0:0:0:1