Chapter 8 OpenBoot PROM 8-13
8.2.6.4 i2c@0,320 Test
The following is an example of a successful i2c@0,320 test:
obdiag> test 4
Hit the spacebar to interrupt testing
Testing /pci@1e,600000/isa@7/i2c@0,320
Testing /pci@1e,600000/isa@7/i2c@0,320/hardware-monitor@0,5c
>> Manufacturer’s ID: 0x41
>> Device ID: 0x31
>> Configuration Register 1: 0x91
>> Configuration Register 2: 0x7f
>> Fan 1 Pulsewidth Modulated output Enabled
>> Fan 2 Pulsewidth Modulated output Enabled
>> Tach 1 input Enabled
>> Tach 2 input Enabled
>> Interrupts on Local Temperature Channel Enabled
>> Interrupts on Remote 1 Channel Enabled
>> Interrupts on Remote 2 Channel Enabled
> Checking for fan1 fault in Auto mode
> Setting ADM1031 to Manual mode while checking for fan1 fault
> Restoring ADM1031 to Automatic Speed Ctrl mode.
> Restoring Config Reg 1 to 0x91
> Restoring Fan Speed Config Reg to 0x23
> Checking for fan2 fault in Auto mode
> Setting ADM1031 to Manual mode while checking for fan2 fault
> Restoring ADM1031 to Automatic Speed Ctrl mode.
> Restoring Config Reg 1 to 0x91
> Restoring Fan Speed Config Reg to 0x23
Testing /pci@1e,600000/isa@7/i2c@0,320/motherboard-fru-prom@0,a8
Testing /pci@1e,600000/isa@7/i2c@0,320/dimm-spd@0,a0
Testing /pci@1e,600000/isa@7/i2c@0,320/dimm-spd@0,a2
Testing /pci@1e,600000/isa@7/i2c@0,320/clock-generator@0,d2
Selftest at /pci@1e,600000/isa@7/i2c@0,320 ............................ passed
Pass:1 (of 1) Errors:0 (of 0) Tests Failed:0 Elapsed Time: 0:0:0:5
To Next Page
Loading...
