Sun Microsystems Blade 1500 - 10 Preparing to Replace Components; Safety Information

10-1
CHAPTER
10
Preparing to Replace Components
This chapter describes common tasks that are completed prior to performing a
remove or install procedure on any Sun Blade 1500 workstation component.
The procedures described in this chapter are written for workstation service
providers and system administrators.
Caution – To prevent equipment damage, review the safety requirements, safety
symbols, and safety precautions in this chapter before you perform any replacement
procedure.
This chapter contains the following topics:
■ “Safety Information” on page 10-1
■ “Required Tools” on page 10-3
■ “Powering Off the Workstation” on page 10-4
■ “Removing the Access Panel” on page 10-12
■ “Removing the Bezel” on page 10-14
■ “Positioning the Chassis” on page 10-16
■ “Finding Your Replacement Procedures” on page 10-18
10.1 Safety Information
This section provides safety precautions to follow when servicing the Sun Blade 1500
workstation.