Chapter 10 Preparing to Replace Components 10-19
TABLE 10-3 Component Replacement Procedures
Number Component Procedure
1 Access Panel “Removing the Access Panel” on page 10-12 and
“Installing the Access Panel” on page 15-5
2 Audio/USB board “Replacing the Audio USB Board” on page 13-30
3 Audio/USB board cables “Replacing the Audio USB Board Cables” on page 14-23
4 Battery “Replacing the Battery” on page 11-22
5 Bezel “Removing the Bezel” on page 10-14 and
“Installing the Bezel” on page 15-2
6 Chassis cross brace “Replacing the Chassis Cross Brace” on page 13-49
7 CPU fan and heat sink
assembly
“Replacing the CPU Fan and Heat Sink Assembly” on
page 11-13
8 DIMMs (Memory) “Replacing the DIMMs” on page 11-2
9 DIMM cooling duct “Replacing the DIMM Cooling Duct” on page 13-22
10 Drive rails “Replacing the Drive Rails” on page 13-59
11 Optical drive (removable
media drive)
“Replacing the Optical Drive” on page 12-9
12 Optical drive cables “Replacing the Optical Drive Interface Cable” on page 14-6
“Replacing the IDE Power Cable” on page 14-13
13 Front fan “Replacing the Front Fan” on page 13-8
14 Hard drive “Replacing a Hard Drive” on page 12-2
15 Hard drive cables “Replacing the Hard Drive Interface Cable” on page 14-10
“Replacing the IDE Power Cable” on page 14-13
16 Motherboard and CPU
assembly
“Replacing the Motherboard” on page 11-43
17 NVRAM “Replacing the NVRAM” on page 11-25
18 PCI card support “Replacing the PCI Card Support” on page 13-45
19 PCI cards “Replacing the PCI Cards” on page 11-28
20 Power switch assembly “Replacing the Power Switch Assembly” on page 14-17
21 Power supply “Replacing the Power Supply” on page 13-2
22 Rear fan “Replacing the Rear Fan” on page 13-15
23 Smart card reader “Replacing the Smart Card Reader” on page 12-15
24 Smart card reader cables “Replacing the Smart Card Reader Cable” on page 14-3
To Next Page
Loading...
