Sun Microsystems Blade 1500 - TABLE 9-1 Subsequent Steps to Test Components in Connection Mode

Chapter 9 SunVTS 9-3
5. Use TABLE 9-1 for the next steps, depending upon which component you want to
test.
TABLE 9-1 Subsequent Steps to Test Components in Connection Mode
Component Steps to Take Successful Test Results
Hard drive
6. Click the plus sign adjacent to
IDE - Devices(uata0).
7. Select c0t0d0(disktest)
for HDD0 or
c0t1d0(disktest) for
HDD1.
8. Click Reset.
9. Click Start.
Connection test starting....
Connection test complete
08/30/04 14:01:59 dt92-238 SunVTS5.1ps5build3: VTSID 2009
disktest.INFO c0t0d0(/pci@1e,600000/ide@d/dad@0,0: ):
Connected <Capacity=30000.35 MB, Mounted=(/), Free=12723.40
MB.>
Optical
drive
6. Click the plus sign adjacent to
IDE - Devices(sd0).
7. Select
c0t2d0s2(cddvdrwtest),
c0t2d0s2(cdtest), or
c0t2d0s2(cdrwtest)
8. Click Reset.
9. Click Start.
Connection test starting....
Connection test complete
DIMM
memory
6. Click the plus sign adjacent to
Memory.
7. Select mem(pmemtest)
8. Click Reset.
9. Click Start.
Connection test starting....
Memory
mem
Status: "Connected
1024 MB physical memory has been found
Connection test complete
Flash
PROM
6. Click the plus sign adjacent to
Memory.
7. Select
Seeprom0(seepromtest)
8. Click Reset.
9. Click Start.
Connection test starting....
Connection test complete
seeprom0
Status: Connected:
Name - motherboard-fru-prom
Size - 0x002000
FullPath - /devices/pci@1e.600000/isa@7/
i2c@0.320/motherboard-fru-prom@0.a8
DIMM0
PROM
6. Click the plus sign adjacent to
Memory.
7. Select
Seeprom1(seepromtest)
8. Click Reset.
9. Click Start.
Connection test starting....
seeprom1
Status: Connected:
Name - dimm-spd
Size - 0x000100
FullPath - /devices/pci@1e.600000/isa@7/
i2c@0.320/dimm-spd@0.a0
Connection test complete