Sun Microsystems Blade 1500 - Page 190

9-4 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
DIMM1
PROM
6. Click the plus sign adjacent to
Memory.
7. Select
Seeprom2(seepromtest)
8. Click Reset.
9. Click Start.
Connection test starting....
seeprom2
Status: Connected:
Name - dimm-spd
Size - 0x000100
FullPath - /devices/pci@1e.600000/isa@7/
i2c@0.320/dimm-spd@0.a2
Connection test complete
DIMM2
PROM
6. Click the plus sign adjacent to
Memory.
7. Select
Seeprom3(seepromtest)
8. Click Reset.
9. Click Start.
Connection test starting....
seeprom3
Status: Connected:
Name - dimm-spd
Size - 0x000100
FullPath - /devices/pci@1e.600000/isa@7/
i2c@0.320/dimm-spd@0.a4
Connection test complete
DIMM3
PROM
6. Click the plus sign adjacent to
Memory.
7. Select
Seeprom4(seepromtest)
8. Click Reset.
9. Click Start.
Connection test starting....
seeprom4
Status: Connected:
Name - dimm-spd
Size - 0x000100
FullPath - /devices/pci@1e.600000/isa@7/
i2c@0.320/dimm-spd@0.a6
Connection test complete
Graphics
accelerator
6. Select Graphics.
7. Click Reset.
8. Click Start.
(The display might flicker
during testing.)
Connection test starting....
Connection test complete
Smart card
reader
6. Click the plus sign adjacent to
Other Devices.
7. Select scmi2c0(sc2test)
8. Click Reset.
9. Click Start.
Connection test starting....
OtherDevices
scmi2c0
Status: "Connected
Device /dev/scmi2c0:
Regs read Test passed
scmi2c0
Status: "Connected
Device /dev/scmi2c0:
Walking 1s Test passed
Connection test complete
TABLE 9-1 Subsequent Steps to Test Components in Connection Mode (Continued)
Component Steps to Take Successful Test Results