Sun Microsystems Blade 1500 - Displaying and Changing Parameter Values; TABLE 6-1 NVRAM Parameter Configuration Commands

6-2 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
6.1.1 Displaying and Changing Parameter Values
NVRAM configuration parameter values are viewed and modified using the
commands listed in
TABLE 6-1.
TABLE 6-1 NVRAM Parameter Configuration Commands
Command Description
printenv parameter Displays the current value for the parameter.
If no parameter is provided, all parameters, their current
value, and their default value are displayed.
setenv parameter value Set parameter to value. Values are typically textual or
numeric. Changes made with the setenv command are
permanent, but require a reset or power cycle to take affect.
set-default parameter Resets the parameter to the default value.
set-defaults Resets all parameters to their default values.
reset-all Initiates a warm boot where most NVRAM configuration
parameters are read. With power cycling or a cold boot, all
NVRAM configuration parameters are read.
password Sets the security-password