Sun Microsystems Blade 1500 - Post Min Max; TABLE 7-5 Post Min Max Output Comparison

7-8 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Note – The 0> that precedes the output text in the preceding and following
examples is the CPU identifier. It indicates the output is from POST. If you do not
see these characters, the output is from the OpenBoot PROM.
7.3.3 post min max
The following is the output of POST with min diagnostic level and max output
verbosity. The duration of POST was 90 seconds. The left column of the table is the
output. The right column is information detailing what is happening. If the POST
output you see from your system does not match that in the left column, use the
information in the right column to help diagnose the problem.
/dat/fw/common-source/firmware_re/post/post-build-
4.16.3/Fiesta/taco/integrated (firmware_re)
POST build path is displayed.
0>Copyright © 2004 Sun Microsystems, Inc. All rights reserved
SUN PROPRIETARY/CONFIDENTIAL.
Use is subject to license terms.
Copyright and license are
displayed.
0>OBP->POST Call with %o0=00000800.01012000.
0>Diag level set to MIN.
0>Verbosity level set to NORMAL.
CPU0 is acknowledged and POST
configuration is identified.
0>Start Selftest.....
Testing is started.
0>CPUs present in system: 0
0>Test CPU(s)....Done
CPU is identified and tested.
0>Interrupt Crosscall....Done
Interrupt handlers are set up and
checked.
0>Init Memory....Done
0>PLL Reset....Done
0>Init Memory....Done
0>Test Memory....Done
Memory is initialized, phase
locked loops (PLL) are reset,
memory is reinitialized and
tested.
0>IO-Bridge Tests....Done
I/O bridge is tested.
0>INFO:
0> POST Passed all devices.
0>
0>POST: Return to OBP.
POST has passed successfully and
returns control to the OpenBoot
PROM.
TABLE 7-5 post min max Output Comparison
Output Displayed What Is Happening
ok post min max
POST is initiated.
TABLE 7-4 post min normal Output Comparison (Continued)
Output Displayed What Is Happening