13-38 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
9. Guide the audio USB board cables through the I/O cable clip at the bottom of the
chassis and close the clip.
See FIGURE 13-41.
FIGURE 13-41 Securing the Audio USB Cables in the I/O Cable Clip
10. Inspect the audio USB board fasteners to verify that:
■ The audio USB board to bracket screws are tight
■ The audio USB assembly to chassis screws are tight.
11. Inspect the audio USB board cabling to verify that:
■ The audio cable is firmly connected to the audio USB board and to the
motherboard at J13 AUDIO.
■ The USB cable is firmly connected to the audio USB board and to the
motherboard at J19 USB.
■ The I/O cable clip is closed and locked.
12. Install the bezel, the access panel, power on the system, and verify the audio USB
board installation.
Refer to:
J13 Audio
J19 USB
I/O cable clip
To Next Page
Loading...
