Sun Microsystems Blade 1500 - Obdiag Menu

8-6 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
8.2.2 obdiag Menu
Once started, OpenBoot Diagnostics polls the system for device nodes. If a PCI card
component is IEEE 1275 compliant, then its connection can be tested. If the device
has a self-test, its function can be verified. When the poll is finished, OpenBoot
Diagnostics lists a menu of the test that can be executed. For example:
The diagnostics displayed are dynamic in that if a device node is not recognized, it
is not listed in the menu. For example: if the Sun XVR-600 graphics accelerator were
removed from the system, its test would not be available, and all remaining tests
would shift location and drop a digit. For example:
_____________________________________________________________________________
| o b d i a g |
|_________________________ _________________________ _________________________|
| | | |
| 1 SUNW,XVR-600@3 | 2 card-reader@0,40 | 3 flashprom@2,0 |
| 4 i2c@0,320 | 5 ide@d | 6 network@2 |
| 7 parallel@0,378 | 8 pmu@6 | 9 rtc@0,70 |
| 10 serial@0,2e8 | 11 serial@0,3f8 | 12 sound@8 |
| 13 usb@a | 14 usb@b | |
|_________________________|_________________________|_________________________|
| Commands: test test-all except help what setenv set-default exit |
|_____________________________________________________________________________|
| diag-passes=1 diag-level=max test-args=verbose,subtests |
|_____________________________________________________________________________|
obdiag>
_____________________________________________________________________________
| o b d i a g |
|_________________________ _________________________ _________________________|
| | | |
| 1 card-reader@0,40 | 2 flashprom@2,0 | 3 i2c@0,320 |
| 4 ide@d | 5 network@2 | 6 parallel@0,378 |
| 7 pmu@6 | 8 rtc@0,70 | 9 serial@0,2e8 |
| 10 serial@0,3f8 | 11 sound@8 | 12 usb@a |
| 13 usb@b | | |
|_________________________|_________________________|_________________________|
| Commands: test test-all except help what setenv set-default exit |
|_____________________________________________________________________________|
| diag-passes=1 diag-level=max test-args=verbose,subtests |
|_____________________________________________________________________________|