Chapter 15 Finishing Component Replacement 15-5
■ The left and right side tabs are tight against the chassis.
■ The bezel and chassis sides align.
15.3 Installing the Access Panel
1. Place the chassis into its upright position.
Refer to “Repositioning the Chassis” on page 15-1.
2. Verify that you have not left any tools, loose screws, or loose components inside
the system.
3. Peel the copper foil end of the antistatic wrist strap from the system chassis.
4. Unwrap the strap from your wrist.
5. Discard the wrist strap and the antistatic mat.
6. Align the bottom of the access panel with the chassis.
7. Tilt the access panel so that it fits into the bottom groove of the chassis.
An arrow on the top edge of the chassis indicates where the edge of the access panel
should be. See
FIGURE 15-5.
To Next Page
Loading...
