Sun Microsystems Blade 1500 - Installing the Chassis Cross Brace

Chapter 13 Replacing Chassis Components 13-53
■ If you removed the chassis cross brace prior to removing the motherboard, return
to
Step 4 of “Removing the Motherboard” on page 11-46.
■ Otherwise, proceed to “Installing the Chassis Cross Brace” on page 13-53.
Note – Do not operate the workstation without the cross brace installed.
13.8.3 Installing the Chassis Cross Brace
1. Open the chassis.
Refer to “Removing the Access Panel” on page 10-12.
2. Locate where the cross brace is installed.
See FIGURE 13-56.