15-1
CHAPTER
15
Finishing Component Replacement
This chapter describes how to finish the replacement of internal workstation
replaceable components, close the system and prepare it for operation.
The procedures described in this chapter are written for workstation service
providers and system administrators.
This chapter contains the following topics:
■ “Repositioning the Chassis” on page 15-1
■ “Installing the Bezel” on page 15-2
■ “Installing the Access Panel” on page 15-5
■ “Powering On the Workstation” on page 15-8
■ “Verifying an Installation” on page 15-11
15.1 Repositioning the Chassis
After completing any procedures that required the chassis to be on its side,
reposition the chassis to its normal upright stance.
● Set the chassis upright.
Using both hands, lift the system chassis from its side, with the opening facing out.
See
FIGURE 15-1.
Note – Do not use the chassis cross brace as a handle.
To Next Page
Loading...
