Sun Microsystems Blade 1500 - Internal Component Upgrades; TABLE 16-2 Sun Blade 1500 Internal Component Upgrades

16-4 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Note – The SunPCi III Pro coprocessor card can be installed in any slot. However,
when the card is installed in the 33 MHz slots (PCI0 - PCI3), SunPCi III video and
disk drive operations have degraded performance.
Note – If a Fibre Channel interface card is not installed, the following message might
appear in the /var/adm/messages file:
WARNING: fcsm: _init: Transport Layer driver ’fp’ load failed
There is no action necessary and you may ignore this message.
Instructions for replacing, removing, or installing PCI cards are provided in
“Replacing the PCI Cards” on page 11-28.
16.2 Internal Component Upgrades
You can customize the Sun Blade 1500 workstation with additional memory and
drives.
TABLE 16-2 lists upgrades, conditions for installation, and where to find the
installation instructions.
Cryptographic Sun Crypto Accelerator
1000
Install the following packages from the supplemental
software CD-ROM:
• SUNWcrypm
• SUNWcrypr
• SUNWcrypu
• SUNWcrysl
• SUNWcrysu
• SUNWdcamn
• SUNWdcar
• SUNWdcav
TABLE 16-2 Sun Blade 1500 Internal Component Upgrades
Component Conditions for Installation Procedure
2 GB DIMM Install in pairs (DIMM0 and DIMM1, DIMM2 and
DIMM3).
“Installing DIMMs” on page 11-7
1 GB DIMM Install in pairs (DIMM0 and DIMM1, DIMM2 and
DIMM3).
“Installing DIMMs” on page 11-7
TABLE 16-1 Conditions for Installing Optional PCI Cards (Continued)
Card Type Product Conditions for Installation