13-22 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
■ Otherwise, install the access panel, power on the system, and verify the rear fan
installation. Refer to:
■ “Installing the Access Panel” on page 15-5
■ “Powering On the Workstation” on page 15-8
■ “Verifying an Installation” on page 15-11
13.4 Replacing the DIMM Cooling Duct
This section describes removal and installation of the DIMM cooling duct. Topics
include:
■ “Identifying the DIMM Cooling Duct” on page 13-22
■ “Removing the DIMM Cooling Duct” on page 13-23
■ “Installing the DIMM Cooling Duct” on page 13-27
13.4.1 Identifying the DIMM Cooling Duct
The DIMM cooling duct is a plastic duct that attaches to the rear fan and covers the
DIMMs installed in slots DIMM0 - DIMM3. The duct routes air from the right edge of
the DIMMs, across the DIMM’s surfaces, through the rear fan, and out the rear
panel. See
FIGURE 13-20.
To Next Page
Loading...
